On the blow molding floor, uneven preform heating doesn’t just cost you output. It shows up as skewed bottles, blown gates, and scrap that should have been good product. The Husky HyPET HPP infrared lamp is built to keep the heating tunnel stable and repeatable—so the cycle you ran today is the same one you can run tomorrow. What matters under the hood This is a short-wave infrared emitter, chosen because it couples heat into PET fast and predictably. The quartz envelope gives you snappy thermal response, and the lamp is engineered to match the Husky HyPET HPP system voltage and geometry. It uses the correct termination and mounting footprint, so it drops straight into the existing lamp holder—no rewiring, no bracket fabrication. output is matched to the heating zone profile, so you get even preform temperature across the row, not hot spots and cold zones. Why this makes sense on the floor Compatibility is the first win. The lamp is specified to fit Husky HyPET platforms, and it also works in standard configurations used across common blow molders—think Matrix and Contiform lines. That lets you standardize spares across multiple machines, which means less downtime waiting for a part and fewer changeover mistakes. With stable infrared output, you hold preform temperature within tolerance, which keeps stretch ratios and wall distribution consistent. The payoff is fewer rejects, better fill performance, and a heating section that behaves the same shift after shift. The practical details that keep you running Infrared lamps are sensitive to surface condition and alignment. Keep the reflector clean, and make sure the lamp seats fully in the holder—even a small gap changes the heat pattern. Plan replacement around lamp life, not failure. Swap on schedule so you don’t get a sudden drop in output that forces retuning. And before you order, confirm voltage and connector type match your specific machine variant; a mismatch can show up as weak heating or premature failure.